VELCRO® 90200 Heavy Duty Industrial Strength

Heavy-duty, hook fastener provides 50 percent more holding power than standard sticky back fasteners. Water-resistant design provides maximum performance even when wet. Fasteners are designed for use on smooth surfaces and can be used indoors and outdoors. To use, simply peel the tape from the fastener and press it firmly into place.

More from the Manufacturer

• Holding
• Industrial

• Self-adhesive
• Heavy Duty

• 50% stronger than standard hook & loop fasteners
• Sticks to most surfaces, including plastic
• Excellent for indoor or outdoor use

Shape:

Strips

Care and Application:

Instructions:

• Clean and dry surface before application
• Peel tape from fastener and press firmly into place
• Adhesive reaches maximum strength after 24 hours

Note: Recommended for temperatures between 0°F to 120°F. Not recommended for fabrics, dashboards, flexible vinyl or underwater use. Continued exposure to full sunlight can damage fastener.

Removal Instructions:

• Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
• Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
• Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
• Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
• Stick the ball on the adhesive which is on your substrate and pull it off
• Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
• If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners

Weight Rating:

1 lbs per square inch up to 10 lbs

Functional Temperature Range:

0-120° F (-18-49° C)